Devices for local smart homes

Sonoff Orb-ZBRBS MINI-ZBRBS-E Zigbee roller shutter wall switch

The cheapest moment to make shutters smart is while walls are still open: Orb-ZBRBS drops a Zigbee panel with key, percentages and scenes into a standard 86×86 box.

Sonoff MINI-ZBDIM Zigbee 3.0 in-wall smart dimmer module

An evening dim-to-30% runs entirely inside the Zigbee mesh — no Wi-Fi, no cloud: the MINI-ZBDIM takes commands straight from the coordinator and relays the network as a router.

Replace a worn double switch outright instead of hiding a relay behind it — the Orb-MW2 panel lands on the wall complete, with two independent 10 A channels.

A worn-out roller shutter button deserves replacing outright, and the Orb-RBS does exactly that — a finished 86×86 wall switch with physical up/down keys and Matter over Wi-Fi.

Evenings at a soft 20% and mornings at full power happen behind your existing switch — the MINI-DIM hides in the wall box and keeps the wall button working.

Three light moods of an open living room — general, dining, accent — on one white Star Ring halo frame, each key on Zigbee 3.0, with a neutral or without.

An old three-key block in a Moldovan hallway turns smart with no new chasing: the grey Star Ring ZS-SR-EU3 runs without a neutral, each key on Zigbee 3.0.

The key's soft glow shows where to press in a dark bedroom without dazzling you: one white key on matte glass, joined to the home Zigbee mesh.

The grey key's matte skin-feel glass keeps no fingerprints and stays warm to the touch on a dark or wood wall — one light run over the Zigbee mesh.

Three light lines on a neutral wire: each key switches LEDs flicker-free, while the white Star Ring halo reads on the wall as a design piece.

A renovation where the electrician pulled the neutral to a 3-gang point: ZS-SR-EU3-LN drives three LED lines flicker-free, grey Star Ring halo on the wall, over Zigbee.

Sit still with a book and the light stays on: the mmWave radar catches the micro-movement a classic PIR misses, ceiling-mounted.

On a white wall two glowing Star Ring discs handle the evening: a tap switches each light group on, a long press eases the brightness down without flicker.

Two LED circuits on one grey glass frame: the Star Ring dimmer sets the chandelier and the spots apart, each gang with its own brightness, through a Tuya Zigbee gateway.

On a matte-white wall the curtain switch all but vanishes: white star-ring key, percentage opening and RF 433 MHz over Zigbee 3.0, rated 3A/600W.

The motorized curtain you ran from a misplaced remote gets a wall of its own: a grey Star Ring glass panel with open/pause/close, percentages and 433 MHz RF.

Pipeline methane near a gas hob can leak before you smell it — this Moes Zigbee sensor catches it at 8% LEL, sounds at 70 dB and alerts the phone.

The steel probe on its 1.5 m lead takes the cold and the liquid; the IP65 body with the LCD stays dry. The SNZB-02LD reads −40 to +115 °C — add a Zigbee 3.0 gateway for alerts.

Shower steam and balcony frost are exactly where the SNZB-02WD belongs: an IP65 case, a −20 to +60 °C range and a 2.2″ LCD; automations come alive once a Zigbee 3.0 hub joins.

The 43 mm body with its tilting antenna takes just one server USB port, and the bundled 0.5 m extension keeps the coordinator radio clear of USB 3.0 noise.

Dozens of Zigbee devices in Zigbee2MQTT or ZHA on a single stick: the TI CC2652P coordinator with +20 dBm output holds up to 200 nodes and reflashes into a router.

Unlike the ZBDongle-P built on the TI CC2652P, revision E runs a Silicon Labs EFR32MG21 with EmberZNet (EZSP) firmware, 20 dBm out of the box and Thread potential.

Pull the old mechanical switch off the wall and ZBMINIL2-E takes its place — a finished Zigbee switch with its own button that asks for no neutral in the box.

One stop by the front door switches off the whole exit route — three independent channels drive the hallway, kitchen and bathroom lights from a single 3-gang plate.