CasaSmart catalog
Hubs, sensors, relays, lighting, cameras, access control and KNX with CasaSmart installation and setup.
34 products
Active filters

1,999MDL

LinkNLink iSG Display Max touch hub: 10″ screen, built-in Home Assistant and Zigbee 3.0, Wi-Fi 2.4/5 GHz, Bluetooth, Matter — your whole smart home from one panel.

A local Zigbee 3.0 plus Wi-Fi hub in one touch panel: add Sonoff sensors and relays directly, run them from the screen and sync with Home Assistant.

Via the built-in Matter bridge, Zigbee sensors and relays show up in Apple Home, Google Home, Alexa and SmartThings; Ethernet RJ45 or 2.4 GHz Wi-Fi, up to 256 sub-devices.

A palm-sized fanless Linux mini-server: runs Home Assistant via MQTT and Zigbee2MQTT, with an onboard EFR32MG24 Zigbee/Thread radio and no separate Raspberry Pi.

With USB Type-C and USB-to-TCP/IP passthrough, the SLZB-MR3U hands its two radios — CC2674P10 for Zigbee, EFR32MG24 for Thread — straight to the PC or server running Z2M.

That heavy-headed feeling after hours in a closed room usually points to CO2 build-up, and the AirGuard CO2 tracks it with an NDIR sensor refreshing every 5 seconds.
1,499

Two radio SoCs in one box — CC2652P7 and EFR32MG21 — so the SLZB-MR1 runs a Zigbee network and a Thread network in parallel from a single PoE or USB-C coordinator.

A multiprotocol bridge that pulls Tuya Zigbee and Thread devices into Matter so the same gear answers Apple Home, Google and Alexa locally.

When the enemy is dust — traffic outside, a wood stove, fresh renovation — this AirGuard is the one: SAWF-07P reads PM2.5/PM10 every 2 seconds and alerts by light, sound and push.

The newest Silabs EFR32MG26 chip with the most memory in the 06 series makes the SLZB-06Mg26 a Zigbee, Thread and Matter coordinator on one board.

Schedules a warm floor across 42 weekly slots and answers Matter locally from Apple Home, Google Home and Alexa — no separate Tuya hub, just WiFi.
999

If your mesh keeps growing, the EFR32MG24 with 1536 KB Flash and 256 KB RAM keeps up — and a reflash turns the dongle into a Thread or Matter radio.
999

The multiprotocol TI CC2674P10 radio with an ESP32-S3 host makes the SLZB-06p10 a coordinator that switches in firmware between Zigbee 3.0 and Thread, over Ethernet or USB-C.

Built on the EFR32MG24, the SLZB-06Mg24 runs Zigbee 3.0 and Thread on one radio, so your Home Assistant network reaches Matter-over-Thread too, not just Zigbee.

Four Matter 16A plugs in one box: a single kit covers the boiler, heater, office and kitchen of a whole home, each with its own energy meter.
899

Fires your gas or water boiler on a 42-slot schedule and by voice from Apple Home, Google Home and Alexa — no hub, just WiFi.
899

Guests and kids dim the light with a real button on the wall — the round Orb-DIM panel replaces the old switch, while app, voice and 1% scene control stay there for you.
899

Replace a worn double switch outright instead of hiding a relay behind it — the Orb-MW2 panel lands on the wall complete, with two independent 10 A channels.
749

A worn-out roller shutter button deserves replacing outright, and the Orb-RBS does exactly that — a finished 86×86 wall switch with physical up/down keys and Matter over Wi-Fi.
749

Evenings at a soft 20% and mornings at full power happen behind your existing switch — the MINI-DIM hides in the wall box and keeps the wall button working.

The 43 mm body with its tilting antenna takes just one server USB port, and the bundled 0.5 m extension keeps the coordinator radio clear of USB 3.0 noise.
699

One stop by the front door switches off the whole exit route — three independent channels drive the hallway, kitchen and bathroom lights from a single 3-gang plate.

Start your smart home where you sleep or work: the Orb-MW1 wall switch brings schedules and voice control to a single room, leaving the rest of the flat for later.
649MDL

In the evening the chandelier rests — one key keeps just the soft sconce light, the other brings back full brightness for cleaning: two lighting zones in one 86×86 frame.
629