CasaSmart catalog
Hubs, sensors, relays, lighting, cameras, access control and KNX with CasaSmart installation and setup.
90 products
Active filters
-1200x1200.jpg)
2,999MDL

The OmniGrip arm tidies objects under 300 g, while 22000 Pa suction and spinning mops handle the floor for you.

LinkNLink iSG Display Max touch hub: 10″ screen, built-in Home Assistant and Zigbee 3.0, Wi-Fi 2.4/5 GHz, Bluetooth, Matter — your whole smart home from one panel.
-1200x1200.jpg)
The white version of the NSPanel Pro: same 3.95" screen and Zigbee 3.0 hub as the black one, differing only by its white frame for light-coloured walls.

A local Zigbee 3.0 plus Wi-Fi hub in one touch panel: add Sonoff sensors and relays directly, run them from the screen and sync with Home Assistant.

Drives your existing roller blind from a 35 mm in-tube motor with 8 N·m torque. Zigbee 3.0, Aqara Home app, Siri/Google/Alexa. Hub required.

Via the built-in Matter bridge, Zigbee sensors and relays show up in Apple Home, Google Home, Alexa and SmartThings; Ethernet RJ45 or 2.4 GHz Wi-Fi, up to 256 sub-devices.

A palm-sized fanless Linux mini-server: runs Home Assistant via MQTT and Zigbee2MQTT, with an onboard EFR32MG24 Zigbee/Thread radio and no separate Raspberry Pi.

With USB Type-C and USB-to-TCP/IP passthrough, the SLZB-MR3U hands its two radios — CC2674P10 for Zigbee, EFR32MG24 for Thread — straight to the PC or server running Z2M.

That heavy-headed feeling after hours in a closed room usually points to CO2 build-up, and the AirGuard CO2 tracks it with an NDIR sensor refreshing every 5 seconds.
1,499

Two radio SoCs in one box — CC2652P7 and EFR32MG21 — so the SLZB-MR1 runs a Zigbee network and a Thread network in parallel from a single PoE or USB-C coordinator.

A multiprotocol bridge that pulls Tuya Zigbee and Thread devices into Matter so the same gear answers Apple Home, Google and Alexa locally.

When the enemy is dust — traffic outside, a wood stove, fresh renovation — this AirGuard is the one: SAWF-07P reads PM2.5/PM10 every 2 seconds and alerts by light, sound and push.

The newest Silabs EFR32MG26 chip with the most memory in the 06 series makes the SLZB-06Mg26 a Zigbee, Thread and Matter coordinator on one board.

If your mesh keeps growing, the EFR32MG24 with 1536 KB Flash and 256 KB RAM keeps up — and a reflash turns the dongle into a Thread or Matter radio.
999

The SLZB-06p7 Zigbee coordinator on the CC2652P7 chip, with a +20dB amp and +5dB antenna, holds a large whole-house mesh over Ethernet, PoE or USB.

The multiprotocol TI CC2674P10 radio with an ESP32-S3 host makes the SLZB-06p10 a coordinator that switches in firmware between Zigbee 3.0 and Thread, over Ethernet or USB-C.

Built on the EFR32MG24, the SLZB-06Mg24 runs Zigbee 3.0 and Thread on one radio, so your Home Assistant network reaches Matter-over-Thread too, not just Zigbee.

Built on the Silicon Labs EFR32MG21, the SLZB-06M is the 06-family pick for those on the Silabs stack — ZHA or deCONZ — with USB-C, Ethernet and PoE at once.

Smlight's original Zigbee 3.0 coordinator on the TI CC2652P, with USB-C, Ethernet and PoE: one device bridges your Zigbee mesh to Z2M or ZHA.

Four Matter 16A plugs in one box: a single kit covers the boiler, heater, office and kitchen of a whole home, each with its own energy meter.
899

Four separate loads on one grey plate by the door: hallway light, stairs, terrace and a sconce each run their own line through a Zigbee gateway, no four-frame wall.

Fires your gas or water boiler on a 42-slot schedule and by voice from Apple Home, Google Home and Alexa — no hub, just WiFi.
899

An open kitchen-living keeps three light lines — ceiling spots, the table lamp, the under-cabinet strip — on one white frame, every key on Zigbee and answering the local hub.

Touch the faceplate on the wall and the warm LEDs glide down for dinner: the MINI-ZBDIM-E swaps the old switch for a complete Zigbee dimmer, no hidden module buried in the box.
4,999MDL
+ installation from 499 MDL
2,999MDL