Functional requirements and KNX bus topology
We record what the system must do and how devices are split across bus lines.
CasaSmart service
Wired systems and KNX
Automation architecture for construction and renovation.
Discuss this service
- Architecture
- Wired connections
- Zone setup
The outcome you receive
Equipment selection and electrical coordination
We choose devices to match the requirements and agree the panel and cable routes with your electrician.
Programming, verification and documentation
We configure the agreed functions, test them and hand over the project documentation.
What we clarify before work
Wired system architecture
We coordinate the electrical panel, lighting circuits, climate, cable routes and control points with your designer and electrician.
More: Network and unified control- Property, renovation stage and installation access
- Exact models of existing equipment
- Essential functions and budget priorities
From need to working system
- 1
We discuss what you need
Goals, project stage, equipment and budget.
- 2
We agree the scope
Equipment, work and terms in the proposal.
- 3
We install and configure
We check connections and the agreed routines.
- 4
We hand over the system
We show your family how to use it.
How pricing works
How is the service priced?
After discussion we prepare a proposal separating equipment, work, additional components and terms. The final cost depends on scope and property.
Is a site visit needed?
Not always — we decide that after the first phone call. The initial phone conversation is free: we clarify what you need and prepare a proposal with the scope and cost. The on-site assessment is paid and credited towards the project under the agreed proposal.
How is the system handed over?
We demonstrate the controls, check the agreed functions and hand over access and the available documents. Support is specified in the proposal.
Let’s discuss your needs.
Tell us about the property and existing equipment. We will agree the scope and next step.